Mike,
Is the mark tone in MMTTY set to the same frequency as you have set in
the K3?
IIRC, the default mark tone in MMTTY is 2175.
73,
Don W3FPR
On 1/6/2016 6:47 PM, Mike Murray wrote:
Bob, Joe, Bill & Mike,
Since I'm new to RTTY, I probably didn't describe my question in correct
terminology - I mainly only operate CW. I'll try again....
I'm using DATA A/AFSK A, setup for low tones (915/170) and the RTTY dual-PB
filter. To illustrate what I'm hearing/seeing, imagine tuning down from
14.090 until you hear and can decode an RTTY signal. Then continue tuning
down 915 Hz (to what I probably erroneously referred to as zero beat) and
then down another 915 Hz, I can now hear the same signal but inverted
(slightly weaker, but definitely there). It is not decodeable, but it is
definitely there. I assumed (yeah, I know) that the opposite sideband
should be suppresed, but I think that's what I'm hearing. Any advice will
be appreciated.
Mike - W0AG
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
