Yes, a solder pot or even the tip of most soldering irons will easily
melt the enamel off.
Brian - W6FVI
Tom McCulloch wrote:
I think Elecraft supplies wire in which the enamel will melt in the
solder pot --- is that true?
Tom
WB2QDG
----- Original Message ----- From: "Rick" <[EMAIL PROTECTED]>
To: <elecraft@mailman.qth.net>
Sent: Monday, February 13, 2006 9:22 PM
Subject: Re: [Elecraft] OT solder pot
Thanks for the info guys, I will have to try straight solder no/flux.
That
will probably eliminate the smoke when at temp. So am I to assume that I
must strip the emamel first, then use paste and dip (again) to tin?
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com