I am finishing up K2 #5113 and have run into a snag configuring the microphone on the K2SB2. I am using a Heil Handi Mic HM-IC. Bob Heil told me to get this mic as he said it would optimize my 706 MKIIG and the K2. I'm using the Kenwood 8 pin cable for the K2, again per Heil's recommendation. I've set up the P1 on the K2SB2 for the Kenwood mics using block jumpers. Setting the K2 power for 2 watts, when I push the PTT, I'm getting a carrier at over 10 watts out. No modulation when I speak, just a constant key down carrier at a very high power output. I'm using a very reliable and accurate Waters analog watt meter. Any ideas on what I've done wrong and what I need to do to fix this? Jonathan Gottlieb WA3WDK K2/100 # 4853 K2 #5113
____________________________________________________________________________________________________________ CONFIDENTIALITY NOTICE: The information contained in this e-mail is confidential, may be legally privileged, and is intended only for the use of the party named above. If the reader of this is not the intended recipient, you are advised that any dissemination, distribution, or copying of this e-mail is strictly prohibited. If you have received this e-mail in error, please immediately notify us by telephone at 612.335.1500 and destroy this e-mail. ____________________________________________________________________________________________________________ _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com