Thanks to everyone for the suggestions. I have confirmed that the mic is wired as per the MH2, including the resistor between pins 1&6. I have done all of the KSB2 alignments as far I can. I still get a >10 watt carrier when I push the PTT in LSB and USB. In CW when I push the PTT, I am getting 2 watts as per the setting. Interestingly, when I am getting the carrier of >10 watts (as measured on a Waters dummy load/watt meter), the K2 display does not show that I am transmitting. With the mic connected but using Tune, I am getting proper output and K2 display reading. Same with the mic not connected. Something is very not right here. Any thoughts? Jonathan Gottlieb WA3WDK
____________________________________________________________________________________________________________ CONFIDENTIALITY NOTICE: The information contained in this e-mail is confidential, may be legally privileged, and is intended only for the use of the party named above. If the reader of this is not the intended recipient, you are advised that any dissemination, distribution, or copying of this e-mail is strictly prohibited. If you have received this e-mail in error, please immediately notify us by telephone at 612.335.1500 and destroy this e-mail. ____________________________________________________________________________________________________________ _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
