LS,
I would try pliers first, but watch the process as you apply pressure.
It may assist if you damage the case more with your soldering iron (melt
more of the plastic) until you can get an Exacto knife edge into it to
help with the process.
As I said, use any tool that works - just be careful not to damage other
nearby components.
73,
Don W3FPR
On 4/12/2016 3:11 PM, lstavenhagen wrote:
Ah yes, thanks for that reminder. If it comes to that, is there a good way to
smush a latching relay body without dangerously ripping the pins out of the
board? I worry that crushing it with say a pair of pliers could stress the
through-holes in the board. Or is it just not that strong?
Thanks,
LS
W5QD
--
View this message in context:
http://elecraft.365791.n2.nabble.com/K2-build-from-purgatory-tp7616239p7616253.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to w3...@embarqmail.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
