Advice requested for the following problem:
Completed and installed the KIO2. That works fine, so far as it has been
tested with the outboard ("twins") KPA100 and KAT100. Next step was to put the
amp and high power tuner aside and install a KAT2 in the base K2. [In case it
matters, the K2 does not have the battery option.]
All went well with the KAT2 until the Bridge Null Adjustment. There are two
strange symptoms:
First, adjusting C55 has no effect, and the display does not behave as it
should. When Tune is held, the display first says HiCur, then it quickly
changes to ATU and then, again quickly, it changes to 000 and stays there.
Adjusting C55 to every possible position changes nothing. Each try produces
the same display: about 2 seconds of HiCur, two seconds of ATU and then 000.
Second, the DC voltage at pin 1 of U4 is way off. In Receive Mode it reads
0.0, as it should. But in Tune mode, at 5 watts indicated, it reads only 0.69
DCV rather than the 3.0 to 4.0 expected.
I haven't put an external power meter on the rig yet but a 15-watt dummy load
gets warm after a while so there does seem to be RF output.
I see no solder bridges, no cold joints, no breaks or shorts thatI can see.
The plugs and sockets have been checked at least five times to assure they are
properly aligned and properly assigned.
Any ideas, anyone? Thanks!
Ted, KN1CBR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
