On Sun, May 15, 2016 at 7:49 PM, Mike Smith VE9AA <ve...@nbnet.nb.ca> wrote:
> It flashes once I stop transmitting (even at 0.1watt output, 0.0w output, > or > in TEST mode)..........and continues to flash forever.(in receive) > That is correct, because the flashing is a receive mode output state only and does not occur while TX. The CPU program code does not flash it while the K3 is in TX state. The program code for this does not consider TX output level, or anything TX for that matter. The K3 CPU is analyzing your RX signals and RX settings situation and giving you a signal whose presence is explained at page 25 in the K3 manual. It is just an output from the CPU, running analysis on the number soup in its memory that is the signal and outputs from other program code. 73, Guy K2AV ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com