It's been my experience that this issue also affects TX output power. My fix
was to add a solder lug to the board side standoff screw and one to the SO239
flange and solder a short buss wire between them.
On 10/28/2016 1:40 PM, Allen Bush via Elecraft wrote:
Update on K3-10 Rx sensitivity problem ..... found the culprit. The single
standoff for the corner of the KANT3 board was loose between the standoff and
the T connector by about a turn. Wiggling the board around caused the noise to
come and go. Tightening the standoff cured the problem....Allen, W0OUU
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to wes_n...@triconet.org
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
