You may simply have the power set too low (below 11W) for the KXPA100 to turn on.
73 Dave AD6A Sent from my iPhone 5s > On Dec 30, 2016, at 9:22 AM, Don Wilhelm <donw...@embarqmail.com> wrote: > > Ray, > > Check to be certain the RJ-45 connectors are fully plugged in. Some of them > are difficult to seat if you hold onto the cover boot. Pull the boot back > and push the plug itself in until it clicks. > > Make sure the other plugs are fully seated - give them an extra push into > their jacks. > > 73, > Don W3FPR > >> On 12/30/2016 11:50 AM, Ray W2RS via Elecraft wrote: >> The KX3 says it has the KXPA100 behind it, but I still get no output. When >> I turn PA MODE to OFF, and turn the amp ON using the front panel switch, I >> get full output but in Basic mode. >> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to d...@ad6a.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com