Ray, I had a simular problem and the solution was replacing a bad cable. You might want to contact Elecraft support .
73, Bill KT5TE On Friday, December 30, 2016 2:29:08 PM CST Ray W2RS via Elecraft wrote: > Ryan, > > > Yes, I am using the correct adapter cable. > > > 73 Ray W2RS > > > -----Original Message----- > From: Ryan Noguchi <ai...@yahoo.com> > To: rsoifer1 <rsoif...@aol.com>; elecraft <elecraft@mailman.qth.net> > Sent: Fri, Dec 30, 2016 8:43 am > Subject: Re: [Elecraft] KXPA100 with PX3 > > >>http://www.elecraft.com/manual/PX3_installation_FAQ_v-0-8.pdf see Figure > >>3.> > >When I tried that, I got no output from the KXPA100 with the KX3 PA MODE > >set to ON. If I set that to OFF, I get full output but then not full > >interaction with the KX3. What am I doing wrong? > So are you saying that you have the KX3, PX3, and KXPA100 all connected in > the exact manner depicted in Figure 3 (which also appears in the PX3 > manual) and you're still experiencing this problem? Maybe I'm mistaken, but > it sounds like you aren't using the KX3-KXPA100 adapter cable. You can't > just connect the KXPA100 RS232 port directly to the KX3 ACC1 port. > > > > 73, Ryan AI6DO > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to b...@watershipfarm.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com