Aaron . . .
In addition to what Don says, I'd recommend setting the KX3's POWER
control to the maximum before running the TX GAIN procedure. I've had
it fail when I had the output set at 5 watts. Running it to maximum
would then result in a successful calibration.
By the way, I always do a TX GAIN calibration after each firmware
upgrade, although I'm not sure it's necessary.
73,
Kent K9ZTV
On 1/2/2017 1:37 PM, Don Wilhelm wrote:
Aaron,
The most common reason for a failure in the KX3 TX Gain Calibration is
a dummy load that does not present a good 50 ohm non-reactive load.
You can check your dummy load at 28 or 50 MHz with an antenna analyzer.
You apparently did not disconnect the KXPA100 when running the KX3 TX
Gain Cal procedure. Remove the KXPA100 and run with the KX3 and the
dummy load only.
If you do the manual procedure in the KX3 manual, it should be good
for all bands where it passed. If you used KX3 Utility, it quits on
the first band that produces an error.
After you get a successful TX Gain Calibration with the KX3 only, then
do the TX Gain Cal for the KXPA100 as indicated in Appendix B of the
KXPA100 manual. Your dummy load must be rated for 75 watts or greater.
73,
Don W3FPR
On 1/2/2017 1:52 PM, Aaron Marroquin wrote:
I have been a lurker on the reflector for almost a year and this is my
first email to request guidance.
I have a KX3 and a KXPA100 and with the recent thread about running a
calibration I figured I needed to do likewise. The amp is a new
addition to
my setup so I am still learning the details. Anyway, while running
the KX3
Utility I get a failure during the calibration process (the output is
below). The amp is in bypass mode and I am using an MFJ-260C for the
dummy
load attached to ANT1.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to k9...@socket.net
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2016.0.7996 / Virus Database: 4749/13692 - Release Date:
01/02/17
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com