AI4EJ wrote:
After reading a downloaded copy of the KXB3080 manual, I'm thinking I'd
be better off doing them both at once to avoid the rework. Any
thoughts, comments or suggestions would be appreciated.
Ricardo,
It's OK to change the KX1 assembly procedure to avoid making the
receiver mods needed for the KXB3080. However, I'd recommend that you
still wind and install the low-pass filter inductors, L1 and L2, as
shown in the KX1 manual. Then, test the rig on 40 and 20 meters to make
sure everything is working. It's a simple matter to remove L1 and L2
when you're ready to install the "LPF1" board that comes with the
KXB3080 kit.
If you decide to annotate your KX1 manual to reflect the
KXB3080-related receiver changes, please let me know. If it works out
better for you, we'd be happy to post the list of changes on our web
site.
But rest assured that the rig will work either way!
73,
Wayne
N6KR
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com