All, (particularly Don or one of the kind folks at Elecraft support)
There are two seemingly interrelated problems in this message that may
indeed be independent.
All other helpful souls - before you post an answer, please read
this ENTIRE message. I am a tech type and no stranger to radio -
computer control systems. I did check cabling to make sure it is OK,
an solidly seated. Firmware is updated and I configured all devices
from factory settings.
My trusty KX3/PX3/KXPA100 kit has been on the shelf for an all too long
respite because the antenna farm was one tree short. It is going back
into regular service alongside an ICOM 7300 now before I build field day
and trail "go kits" for my beloved KX3 system. Since it takes about 2
hours to get everything behaving here - this is going to be a lousy
EMCOMM and Field Day solution... For the trail, it doesn't matter
because the KX3 goes alone.
Here goes: As I was bringing things back online today, I found a
stickynote to self about an issue I had with the PX3 and the KXPA100
before I stopped using the kit in December. I am still observing the
following behavior:
When the PX3 is powered on "cold", it takes about 5 minutes for the
display to light up.
This occurs regardless of the power on jumper position which is
currently back in the enable (pin3/4) position.
This occurs whether the KX3 or the KXPA100 are cabled in.
Once the PX3 is "warm". I can turn it off and then on again and it
comes right back to life.
During this PX3 "braindead" period, when the entire setup was cabled up,
the amplifier will not work properly. To make things more annoying,
after the 5 minute braindead spell is over and the PX3 is working and if
the KXPA100 decides to cooperate, I have to go back into the menu,
enable the KXPA100, then reset the power level for the whole system
every time this happens... but the PA does not always stay on!!! Then I
have to tweak the whole system until it decides to work... when the
KXPA100 is enabled by the KX3 menu, it holds PA MODE ON a moment and
then reverts to PA MODE OFF without my doing anything.
Today in desperation, I tore everything down and re-connected several
times and FINALLY all 3 unit talked to each other and the PA stayed on.
This started occurring in the fall of 2016 (September or so), I do not
recall that any of this happened when I first assembled the PX3 and
began to use the KXPA100.
So before the inevitable deluge of helpful "Did'ja look" comments come -
current firmware is :
KX3 is at MCU version 2.38, DSP is at 1.37
PX3 is at MCU revision 1.39
KXPA100 is at revision 1.39
AND ALL units are set for 38,400 and communicate with the computer.
All cables have been checked and are properly seated.
Thanks in advance for your help!
Jack Spitznagel KD4IZ
KX3 #6029 PX3#0941 KXPA#1488
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
