Carter,
As a first step:
Check the seating of all the plugs, give them that 'extra push'.
The is especially true of the RJ-45 plug. Remove it and make certain it
goes back in with a little click.
73,
Don W3FPR
On 3/4/2017 3:48 PM, Carter Craigie wrote:
Hello Fellow Elecrafters,
I have an Elecraft KX3, connected to an Elecraft PX3, and both are connected
to an Elecraft KXPA100 Amplifier, and to my Dell laptop computer.
All had been working well, and before leaving for an out-of-state trip, I
disconnected the antenna cable from the rig, as well as the power cable. I
may have disconnected something else, but all cables are now connected right
where they should be now.
Upon returning from the trip, and re-plugging everything, I can get no more
than 5 Watts out of the KX3.
The green LEDs illuminate on the KXPA100 Amplifier, and the Switch is in the
OFF position. The KX3 is receiving properly with good audio, and all signals
show correctly on the PX3.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
