This also applies to the K3S. Wayne
> On May 14, 2017, at 12:53 PM, Wayne Burdick <n...@elecraft.com> wrote: > > Hi all, > > If you use a K-Pod, or K3 macros in general, you may have occasionally > noticed that a macro’s name was flashed on VFO B but the macro itself didn’t > get executed. This would only happen if you also had an external application > such as LP-Bridge or HRD polling the radio continuously. > > The K-Pod is affected because it uses K3 macros to define its switch tap/hold > behavior. > > I found the source of the problem and will have a new field-test firmware > release by tomorrow. If you have time to test it, please email me directly. > > 73, > Wayne > N6KR > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com