> On 16 Jun 2017, at 00:28, Dave AD6A <d...@ad6a.com> wrote: > > I'd like the power supply to be able to be turned "on" by a single button > push on the front panel of the amplifier (on the desk).
Would be good if "remote-on" would be possible as well. Possible options include serial command, a dedicated I/O-line, or control lines of a serial port. Such a setup could also be a nice basis for remote operation, including dead man switch type setups, power sequencing and so on. Going a bit outside the scope of the post I'm replying to, such a sequencing could also be useful for a later setup of a KPA1500, and a "headless" box similar to K3/K3S, with a RemoteRig-type control. Small controller unit to power on both the KPA1500 and the headless box as requested by RemoteRig interface, then operate as normal. Allow controller unit to include a timer, disconnect on lost connectivity to the RemoteRig, etc. Couple of remote GPIO, to allow for sensors based on users need (someone entered the room? Ambient temperature? Temperature at amp chassis?), and things are starting to look very good for remote users. Terje / LB8KH ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com