Art,
Yes, the K-Pod knob moves at 1/2 the rate of the K3 VFO knob. It is
intended to be that way.
The software does not change that relationship. There were counts being
lost between the K-Pod and the K3. That was what the buffer fixed.
73,
Don W3FPR
On 6/17/2017 11:21 AM, Art via Elecraft wrote:
The description of the update states ":Changes encoder operation to allow the K-Pod
to buffer encoder counts to the K3. This helps the K3 and K-Pod remain in sync."
However, that's not my experience. I have the VFO set to 200 CTS, so the K-Pod
should match it after this update. However, the K-Pod only moves 100
CTS-exactly half of what the main VFO moves. Tried going to 400 CTS on the main
VFO. K-Pod then moves 200 CTS.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
