I think he may be saying that when the KXPD3 is fully inserted the rig goes into transmit .... but it works properly when it is pulled out a little ...
-----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Don Wilhelm Sent: Saturday, September 09, 2017 1:34 PM To: Ignacy; elecraft@mailman.qth.net Subject: Re: [Elecraft] KXPD3 problems Ignacy, I have no idea why you would want to operate it when not fully inserted and the securing screws tightened. It does not sound to me as though you have a problem. 73, Don W3FPR On 9/9/2017 3:02 PM, Ignacy wrote: > KXPD3 worked well until last week (ES/NO9E). Now as Z3/NO9E, KXPD3 > sends when fully inserted. When partially inserted, it works OK. It > seems that the bottom pins in KX3 are a bit lower and the top ones are > a bit recessed. But perhaps it was always that way. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to n...@comcast.net ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com