Hi,
No, I didn't.
However, it seems that the amp is not blown.
I have no idea what's happening...
Ok, Elecraft recommended a TX Gain calibration. That was successful on all
bands.
I changed all the RF cables and the KXPA100 still shows no output...
However, this was on 20m.
If I switch bands, the KPXA100 is working fine on all other bands. It just
so happens that this seems to happen only on 20m.
Everything looks the same as far as I can tell, same antenna (all testing is
into a dummy load)
So it is only on 20m.
What have I missed?
Thanks, Tom
-----Original Message-----
From: Don Wilhelm
Sent: Friday, October 27, 2017 4:34 PM
To: Tom ; Elecraft
Subject: Re: [Elecraft] Did I fry my KXPA100?
Tom,
Did you connect the KX3 Keyout signal into the KXPA100 PA KEY input?
That is necessary for 'Basic Operation' - see page 18 of the manual.
73,
Don W3FPR
On 10/27/2017 3:24 PM, Tom wrote:
Hi,
Just to be sure, I disconnected all control signal, only RF into the amp
at 10W....
No output, but no errors in the KXPA100 utility.
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
