Scott,
I can think of 2 things to check:
1) Are the RJ45 connectors plugged in fully? sometimes the hood
prevents full insertion - pull the hood back a bit and give the jack
body a push - if it clicks, it was not fully seated.
2) Check to be certain the ACC1 cables are connected properly. The ACC1
cable from the KZPA100 goes to the PX3 ACC1 PC jack. The PX3 ACC1 XCVR
jack then connects to the KX3 ACC1 jack.
73,
Don W3FPR
On 11/14/2017 1:33 PM, K. Scott Wood wrote:
I need to consult the collective intelligence and experience of the Elecraft
Group about a problem with my KX3 - PX3 - KXPA100 Line.
After almost a year of moving and renovations, I got back on the air a couple
of weeks ago with my KX3 Line. It worked flawlessly when I took it apart for
the move, and the KX3 and KXPA 100 worked properly alone when I recently
fired it up. However, when I turn on the PX3, it causes the amplifier to
switch to antenna two, turns off the amplifier and switches the KX3 PA menu to
off.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
