Jeff, Have you done the Opposite Sideband Nulling (page 26 in the manual). Make certain the RX IQ plugs are fully seated at both ends. See Trobleshooting on page 33 in the manual.
73, Don W3FPR On 12/22/2017 5:15 PM, Thorpe, Jeffrey wrote:
Probably a dumb question. New to using pan adapters, and just got my PX3 put together. I hooked it up to my KX3, tuned around on 40m (using a home-brewed AS-2259 NVIS type dual dipole for 40m and 80m) and I get really strong signal indications close to 19khz both above and below the center frequency on the display. It doesn’t matter where I tune in the band. If I adjust the scale, the signals stay at the +/- point of about 19khz. They appear stronger than any other signal in the display. I am running the KX3 off internal batteries, and the PX3 off a LiFePO4. Are these signals from something outside being picked up in the cables between the KX3 and PX3, a problem with the PX3, or something else (like, maybe, me)?
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
