Yes I did exactly what Lyle describes. I was sure I had not done that when it was suggested to me by Elecraft when I had the same problem.
But I had !! I corrected it, no harm done and it then worked fine. Barry VK2BJ On 27 March 2018 at 03:53, Lyle Johnson <kk7p4...@gmail.com> wrote: > When installing the DSP board,it is very easy to mis-align the 5-pin > connector between the front panel board and the DSP board. This connector > carries mic audio from the front panel microphone jack to the DSP. > > 73, > > Lyle KK7P > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to vk...@optusnet.com.au > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com