I suspect that what you most likely need is for Line In to be used during digital mode operation (with the microphone muted), and the microphone to be used during voice mode operation.
The audio input settings for voice modes and digital modes are stored independently, so this is easy. With the radio in SSB, you set MIC SEL to wherever your microphone is plugged in, with the appropriate bias and level settings. With the radio in DATA A or AFSK A mode, set MIC SEL to LINE IN and adjust the Mic gain control to get the required 4-5 bars of ALC meter reading in digital modes. The only reason you might need MIC+LIN to be set to ON is if you were using the computer sound card as a digital voice keyer in voice modes, in which case you might want both microphone and line in to be active while operating in voice modes. In this case, set MIC+LIN to ON with the radio in SSB, and OFF with the radio in DATA A or AFSK A. In both cases, you will only need to set this up once; the settings are remembered independently in the two modes from then on. 73, Rich VE3KI W7HSG wrote: Does any one know the command for both Mike in Front Panel and Line in rear panel? I need both at the same time, Mike for voice and Line in for digital. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com