I finished building my K2, finished alignment and all works fine. I
since installed the SSB and AF filter. Starting the CAL FIL setup I
decided to lower the CW Tone from 750Hz to 650 Hz so I needed to do the
CAL FIL complete including the CW Filters. I can not get the K2 to go
to CW R mode. The A/B [REV] button only switches between VFO A and B
A hold of the button does not activate CW R, What do I have setup wrong?
The modes do step through CW, U and L normally, I do have the OP1 filter
showing up, I have not enabled RTTY mode.
Thanks,
Gordon - N1MGO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
