Mark,
The CW reverse is indicated by a bar over the "c" to the right of the
display. Holding the REV button should toggle it.
Likewise, that same button will toggle between USB and LSB.
73,
Don W3FPR
On 6/10/2018 3:37 PM, Mark Petrovic wrote:
I am performing the first alignment and test of the RF board of my K2 S/N
7809. On page 66 of the manual, I'm instructed to read page 91 of the
operating instructions to get familiar with the CAL FIL settings. Page 91
says to work through the CAL FIL examples on page 93, wherein we work
through setting the BFO frequencies. One of the steps says to hold CW RV
to switch to CW Reverse. When I press and hold CW RV, should I expect some
visual element to change to indicate that I am in this 'reverse' mode? I
don't see any visual indication. How do I know the press and hold of CW RV
was effective?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
