I think this is a low power message indication that the atu isn't seeing enough
power to do a tune. You might want to check the cable between the atu and the
rf out jack on the motherboard. It can come loose and can also become damaged
with the removal of the lid, etc. Also make sure the ribbon cable is seated
properly. Does it only happen on an antenna, or does it also happen on a dummy
load?
Philip,
I've only recently installed it and the cable from the ATU was locked well into
place. I'll check, anyway. I'll also have a go with a dummy load.
I think the general view is that I'll need to set the power level above 2 watts
before I do the tune - it works OK then.
I'm running it into a rather ancient Kenwood TL-120 linear which on occasion
doesn't present a well-behaved load to the K2, so I get the ATU on the K2 to
cope with it. If I set the power on the K2 much above 1-2 watts, the linear
doesn't seem to like it ie trips out.
73
Bob
2M0KDZ
#5339
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com