I really should have said antenna switch controller. I have two
controllers.
A) Is the DX Solutions SAS-6 (Smart Antenna Switch-6)
B) The KK1L 2x6 Controller.
Both devices worked flawlessly from the FTdx5000.
Will WC2L
On 7/4/2018 11:55 AM, William Liporace wrote:
Hi Folks,
I thought it was me, but I guess not... When I hook up a cable to the
ACC plug for band data output, I get about 4.8v (slightly less than
5v). When I hook up the radio to any antenna switch that has band data
input, the voltage goes down to 3v. This is not enough to drive the
antenna switches. This is a new KIO3B board, so is it a bad board? Is
there something else not set right that I am missing?? I didn't
anything in the manuals..
TNX Will WC2L
--
William Liporace WC2L
http://www.wc2l.com or http://dxc.wc2l.com
AR-Cluster Node telnet dxc.wc2l.com or 144.93 MHz
w...@wc2l.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
