Yes, you will need a Y cable, connect to RX ANT IN and OUT. The junction
of the Y goes to the SDR Play. To activate, press the RX ANT on the
radio. This sends the ANT 1 or ANT 2 signal to the Out and then back to
the In via the Y cable, while feeding same to the SDR play.
Works great. I use HDSDR with OmniRig to control my K3S from the
computer and if configured as such the SDR play follows the K3S.
In order to simplify a nest of cables and forgetting to push the RX ANT,
I finally resorted to using the IF OUT to the SDR play. Again the HDSDR
software allows configuring such that it tracks the K3S in all modes and
frequencies.
73
Bob, K4TAX
On 7/17/2018 8:16 AM, Steve Muenich wrote:
Hello gang,
Is there a proper port on the K3S to connect a SDRPlay that would allow for
sharing the main antenna while receiving, then be disconnected and isolated
when the K3S go into transmit?
Thanks
Steve, NA5C
K3S 10121
Sent from my mobile device
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to rmcg...@blomand.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
