Uli, There is another menu item for calibration of the DDS (transmit frequency). The BFO just calibrates the received frequency display. I don't recall where it is in the menu, take a look at the assembly manual, the final alignment instructions, and look for the DDS adjustment.
73, Mike N2HTT ----- Original Message ----- From: Uli DF5SF <[EMAIL PROTECTED]> Date: Sunday, May 21, 2006 11:36 am Subject: [Elecraft] New KX1 #1424 > Hello, > > now finished assembling my KX1 with KXB8030. > > Problem: > I have a test oscillator on 10109 kc. > BFO = 00, RIT = OFF > After adjusting DDS (-49) I read 9.00 and receive this signal as > a 620Hz tone. > But my transmit frequency is 10108.5 kc. > Is this normal or what to do ? > > 73 > Uli > DF5SF > > --- > http://www.avast.com Outbound No Virus found. > > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com