For my KX3, I built a dummy load from three 150 ohm 2 watt
resistors and a BNC connector. The resistors are in parallel
with a lead going to the center conductor of the connector. The
other leads are folded back over the resistors and attached to
the ground-side of the connector. The whole outside is then
covered with a piece of coax braid. It does well on the antenna
analyser test Bob, K4TAX suggests.
It lives in a pocket of Rose's case and goes where the radio goes.
73 Bill AE6JV
---------------------------------------------------------------------------
Bill Frantz |"After all, if the conventional wisdom was
working, the
408-356-8506 | rate of systems being compromised would be
going down,
www.pwpconsult.com | wouldn't it?" -- Marcus Ranum
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com