You want the ACC2 jack. From page 5 of the KX3 manual:
"Keyline Out and GPIO (ACC2) The 2.5-mm stereo ACC2 jack provides a keyline output (ring contact) and a general-purpose 3-volt logic signal (tip contact). The keyline output goes low during transmit, and can be used for transmit/receive switching of linear amplifiers and transverters. For keyline voltage and current limits, see Specifications.” wunder K6WRU Walter Underwood CM87wj http://observer.wunderwood.org/ (my blog) > On Jan 4, 2019, at 6:11 PM, Rick McGaver via Elecraft > <elecraft@mailman.qth.net> wrote: > > A friend has a KX3 and want to use a HF Packer Amp. The cable that goes to > the PTT on the Amp, what is on the other end and it goes where. I see no docs > on this anywhere. Any guidance would be appreciated. > Rick. NK 9G > > Sent from my iPad > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to wun...@wunderwood.org ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com