The fault ability of the KPA500 is fast, BUT I would not test that with
100 watts. The tuned input can only take so much abuse.
ALC should be used as a secondary (emergency) limiter, not for everyday
use. It will cause distortion (in part from overdriving the amp).
Proper management of the input (power out, proper compression levels
etc) is THE best way to manage the combination.
Rick NHC
On 2/28/2019 10:07 AM, Jim Lageson wrote:
I have never owned an amp before and recently put together a KPA500. All
seems to be working well, but I have a few questions. I am using with a
IC-7300.
How important is the ALC cable? I notice it is not included in the Basic
Cabling Diagram in the manual but is discussed later in the manual.
If I were accidently to run 100 watts into the KPA500 will the PWRIN HI
Hard Fault/STBY protect itself before any damage is done. Would ALC protect
me from that?
Is it standard procedure to keep the KPA500 in line when turned off and not
in use? I see you may run up to 200 through the KPA500 in STBY.
Is there any concerns or settings on radio when running full break in on CW?
Thanks
Jim-N0UR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
