Ken, 3.79 is nominally 3.8 volts. However, since your 8 volt regulator is on the lower side of tolerance rather than the high side, I suggest setting the AGC Threshold for 3.7 or 3.75 volts - either will work and after you complete your K2 you may want to optimize the AGC Threshold for maximum receiver sensitivity. Ask about that when you are ready - or check the archives for the optimizing procedure.
73, Don W3FPR > -----Original Message----- > > Hello Elecraft K2 Builders.... > > > Page 47 says to adjust R1 for a suggested setting of 3.80 volts. > The maximum I can get is 3.79 at "full" rotation. > > Supply voltage is 13.8V on the K2 voltmeter. > > Any comments/suggestions much appreciated. > > THANKS !! > > > Ken...W2GIW > > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
