I suspect I may have an issue with the Line In port of my K3, as my ability to 
TX in any digital mode has gone away.

Setup:
1. Using a Tascam US-122 MKII outboard sound card.
2. MIC SEL is set to Line In on the K3.
3. Digital software, e.g., WinWarbler and WSJT, have the Tascam selected for TX 
and RX.
4. Mode selection for FT8 is set to Data, for RTTY is set to AFSK 45 bps.
5. Levels are the same as when this system worked – K3 Mic level is set around 
43-44.

Symptoms:
1. When I try to TX on FT8 from within WSJT, the K3 red TX light comes on and 
over my headphones I can hear a steady tuning tone, but I have no power out, 
not one bar.
2. During TX I do hear “behind” the tones a brief low level buzzy/crackly sound 
that recurs every second or so.
3. I get the same results as above when trying to TX in WSJT, though I hear 
tones typical of a transmission vs. a steady tone.
4. I get the same results as above when I switch to RTTY and TX within 
WinWarbler; RYRYRY, but no power out.
5. The Tascam and WSJT work fine together to decode FT8 signals.

T-shooting Steps to Date:
1. Uninstalled, rebooted and reinstalled all Tascam software and current 
drivers. Same results.
2. Tried the Line Out from the internal PC soundcard to the Line In on the K3. 
This also involved using a different cable from that connecting the Tascam to 
the K3. Reconfigured the digital software to use the internal sound card for 
TX. Same results as described above (including the noise).
3. Verified the K3 does TX (at least on CW).

I suspect the board with the Line In port may have gone bad, but not sure if 
that’s the issue. If so, is there anything further worth checking or should I 
just replace the board?

Thanks for any guidance!

73 Paula k9ir

Sent from Mail for Windows 10

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com 

Reply via email to