Just been checking the KIO2 Programmers Reference (as used by the KPA100 AUX IP port too). It doesn't seem to be particularly easy to use the K2's scanning modes from the serial interface, and perhaps even impossible if I want to scan with "AF ON"?
Presumably it's considered easier to do something like: FAnnnnn; [set VFO A freq] UP; [up 10Hz] UP; UP; ... or UP3;UP3;UP3; or whatever? This would work, would give me more feedback/control over exactly where the frequency is right now, but seems to be an awful lot of commands to achieve something the K2 can do itself. Any other ideas, and/or have I missed something? Thanks -- "Nosey" Nick Waterman, G7RZQ, K2 #5209. use Std::Disclaimer; [EMAIL PROTECTED] After a number of decimal places, nobody gives a damn. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com