----- Original Message ----- From: "rlpend" <[EMAIL PROTECTED]> To: <elecraft@mailman.qth.net> Sent: Sunday, June 11, 2006 10:55 AM Subject: [Elecraft] re: K1 frequency range
> If I exchange C2 with C2a to expand frequency coverage to c. 150 khz > will I need to re-peak all the filters and re-calibrate the receiver? > Thanks. > > P.S.: the backlight kit is a wonderful addition to the K1. > > Bob N5JYW > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com ---------------------------------------------------- I just made this change. No need to re-peak the filters or re-calibrate the frequency readout. I did, however, have to adjust the turns on the VFO coil, to get the VFO range in spec. I don't remember if I had to expand or compress the turns. I am happy with the result. I get about 170 khz tuning range. Thats an average of 17 khz per turn. Not bad. And the backlite is a nice touch. 73 Rick Dettinger K7MW _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com