Jim,
Likely nothing wrong. If the K2 is ever powered when that menu
parameter (which follows the heatsink temperature) is set to a low
value, the parameter will try to go below 0 degC - but the math cannot
handle negative values, so it instead goes to a high value.
It is wise to check the CAL TPA parameter periodically if one has the
KPA100.
73,
Don W3FPR
On 11/12/2019 2:28 PM, Jim KO5V wrote:
Hi again Don,
I just finished that. I found the setting to be 143C. something must be bad;
possibly R6 or the temp sensor?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com