I recently obtained a P3 and I'm and exceedingly happy! Now that I own it I feel bad that I wasted a few years trying other solutions that introduced noise and undue complexity into my station.
Just a few notes and questions because the manual is helpful but I don't fully understand what I'm reading yet. 1. When using QSY the P3 unit often slides. How do most of you prevent the unit from sliding? 2. The signal/noise floor jumps a lot and I'm not sure if that's due to local interference or something in my setup. Based on reading I likely need to noise troubleshoot/filter my station. I don't see an AGC setting for the P3. Any suggestions? 3. What serial number requires the mod? My serial is 3251 4. I need a serial port screw stud - can I buy that from Elecraft when I purchase a cable + vga card? 5. Is there a quick setup cheat-sheet anyone has for the P3? Thanks in advance Jerry Moore AE4PB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com