The cable shown in the XG3 manual can be ordered from Elecraft as the
KXSER cable. Or it is easy to build your own if you have the proper
connectors. The KXUSB has the same pinout at the KX2/KX3/XG3 end, but
plugs into a USB port instead of a serial port.
73,
Don W3FPR
On 3/17/2020 9:54 PM, M. George wrote:
Is the same cable as you would use with the Elecraft XG3, take a look at
the end of the XG3 manual:
https://ftp.elecraft.com/XG3/Manuals%20Downloads/E740154%20XG3%20Owner%27s%20Manual.pdf
The tip(1) is TX and the Ring(2) is RX... and well you guessed it... the
Sleeve(3) is Ground. So on a DB9 (D-Sub) connector, pin 3 goes to the Tip,
Pin 2 goes to the Ring and Pin 5 to the Sleeve.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
