The P3 has a menu entry to calibrate its frequency MENU:Ref Cal The calibration prodedure is on page 37 of the manual. I like to use an AM broadcast station (preferably near the top of the band) for calibration because these frequencies are highly accurate and AM mode puts the carrier right at the center of the P3 display.
Alan N1AL On 2020-04-24 19:13, Frank O'Donnell wrote: > Here's what I'm sure is a beginner question. > > If I feed an accurate signal from a waveform generator into my K3S, on the P3 > it appears right about 120 Hz higher than the actual frequency. This seems to > be independent of the mode the K3S is in. What causes that? > > I noticed this when I had my K3S/P3 running while working the ARRL Frequency > Measurement Test with other gear, and was curious about it. > > Thanks much, > > Frank K6FOD > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to a...@elecraft.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
