Firstly thanks to all who replied to my original post, if I didn't reply personally..
On closer inspection I have so far found 2 ceramic door knob capacitors that were falling apart !! These were not in the input coil alignment section, but near the valves and band-switch in the amp. For you RF guru's out there... I have a couple of questions.. 1. Is it possible to solder these capacitors back together ? They are the flatter type doorknob caps and basically what has happened with both of them is that the one of the screw housings has fallen off the side of each cap (hope this makes sense). 2. Secondly, if this is not advisable, can I just replace these with the standard type (barrel shaped) door knob caps, as long as the KV rating is greater or equal to that of the originals ?? Surplus sales have these for under $20US each Again apologies for the off topic post Regards from a chilly Sydney.. David, Vk2NU >Date: Tue, 27 Jun 2006 23:11:36 +1000 >From: "David Douglass" <[EMAIL PROTECTED]> >Subject: [Elecraft] Slightly off top amp question >To: <elecraft@mailman.qth.net> >Message-ID: <[EMAIL PROTECTED]> >Content-Type: text/plain; charset="us-ascii" >Apologies in advance for the off topic question! >I've just bought an old FL-2100B amp to do up, and run with my K2 (I have >the bits and pieces on order for the external keying circuit!!)................. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com