Hi Rich, I copied this to the designer of the KRC2 to get his input/suggestions.
73, Wayne N6KR > On May 20, 2020, at 3:34 PM, Rich <rwnewbo...@comcast.net> wrote: > > I had been in conversation with Elecraft Tech Support, but I have not heard > back from them in three weeks. So I will throw this out to the group. > > It appears that there is an error in the KRC2 manual and it is not shown in > the Errata sheet. > > On page 24 the manual states the following when connecting the KRC2 to an > Icom radio: > > "For this reason it is recommended that the reference input setup be used. In > this configuration, the band data is connected to pin 9 and the 8 volt > reference is connected to pin 4. This mode is set with jumpers W1, W2 and W3 > installed." > > Directly below that statement this statement appears which confirms the first > statement: > > "• Analog band input on J1/2 pin 9 with reference voltage on J1/2 pin 4:" > > If you look at the schematic it shows Pin 9 as Reference voltage (8v) and Pin > 4 ALC (band voltage) > > So they are reversed. > > Since the wording and the schematic disagree. > > Does anybody have any idea which is correct? > > My unit is not working properly. I sent it in for repair but 1 hour of labor > is about the cost of the unit. So they returned it and I am trying to > troubleshoot it myself > > Rich > > K3RWN > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to n...@elecraft.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com