Sorry, Typo, I am trying to do the RX (not RF) calibration.
My bad. I tried a different USB cable and my K3s Utility was out of date so I updated that but there was no change. Still have the same error. /randy > On Jun 4, 2020, at 3:45 PM, Nr4c <n...@widomaker.com> wrote: > > Exactly what are you trying to do? > > The RF GAIN Calibration is done with the transmitter and a “Dummy” load. No > need for the XG3. Look in manual around page 52. > > Sent from my iPhone > ...nr4c. bill > > >> On Jun 4, 2020, at 4:57 PM, Randy Diddel <k5rhd...@gmail.com> wrote: >> >> Hello again, >> >> I sent this message a few days ago but did not get a single response. I have >> emailed Elecraft support but due to COVID-19, I am not sure when I will get >> a response from them. So here is my message again: >> >> >> Anyone? >> >> I still have not been able to figure this out. >> >> 73 >> >> K5RHD >> >> /randy >> >>> On Jun 2, 2020, at 4:42 PM, Randy Diddel <k5rhd...@gmail.com> wrote: >>> >>> Hi all, >>> >>> I am trying to do the RF Calibration test using my new XG3. I am getting >>> the error below. I have all firmware up to date on the K3s and the XG3. I >>> even tried reloading the firmware on the K3s just to see if that worked. Of >>> course turning it off and back on again did nothing either. I DO have the >>> SUB RX on this rig as well, ideas? >>> >>> TIA and 73, >>> >>> K5RHD >>> /Randy >>> >>> >>> Elecraft K3 Utility for OS X Revision 1.18.6.28 >>> OS X Version 10.15.4 >>> K3 MCU revision 05.67. RS-232 speed 38400 bps. >>> Turning sub receiver off >>> Unlinking VFOs >>> Selecting Antenna 1 >>> Setting mode to CW >>> Turning squelch off >>> Turning Preamplifier off >>> Turning Attenuator off >>> Setting Filter Width to 100 Hertz >>> Setting RF Gain to maximum >>> Turning CW Tune on >>> Writing factory default calibration data >>> Writing calibration table to DSP >>> Delay 100 ms >>> K3 did not respond to DSP command >>> !bc20007401350137023802390139033C033A023C033B033D043E053E063D063C083F093C0C3C0D3E0E3D103F0F3C0F400E3F0F3F103E143F1A401F41223F273F2D41333F3E404A4150403B3F113E0244013E003F0041003F003F0140004000400141033D064313412041243F18400B410742033C0442014100EE007451236D5338; >>> Power cycle K3 and try calibration again. >>> >>> >>> >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:Elecraft@mailman.qth.net >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to n...@widomaker.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com