Robert,
Those instructions are for heat-strippable wire. If you have enamel or
formvar covered wire, that must be mechanically stripped.
73,
Don W3FPR
On 6/12/2020 10:02 AM, Robert G Strickland via Elecraft wrote:
Here's an old problem that I've never solved: how to strip the enamel
insulation from wires for winding toroids.
The instruction say:
-dip in a solder pot which I don't have
-use a soldering iron to, presumably, burn the insulation off which has
never worked for me.
Leaving soldering pots aside, the hot iron approach has never burned off
any insulation even with tip temp's hovering around 1000F. Just doesn't
happen. Maybe it's the soldering iron, maybe my method, but whichever,
the enamel insulation just sits there. I end up using a file to scrape
off the insulation which is tough on the wires and hard to predict when
enough is enough. Any insightful hints? Thanks much.
...robert
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
