I loaded it here, and had an initial fail during the first FW load
(started ok), requiring re-power (with battery remove) and forced MCU-LD
load.
I was connecting serial via a PX3, and reconnected direct to KX3 on
forced load, all ok. I also rebooted W10 PC prior. Is FW load usually ok
when using KXPA100 or PX3 as primary CAT ? I have two KX3 setups.
KX3 version 2.95 firmware is now available. It supports the "SW;" remote
control command (read SWR value during transmit).
One reason we added support for this command is that Joe, VE3VXO, has built a hardware
module that polls the rig (using the SW; command) and outputs a "recognizable audio
pattern proportional to the current VSWR." Feel free to contact Joe if you have
questions about this. At least one blind KX3 operator is already using one.
73,
Wayne
N6KR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
