Murray,
I suggest that you build the RF Probe that was included with the K2
kit. The schematic is shown on page 9 of Appendix E along with the
assembly instructions.
After that, start on Appendix E page 12 - Preparation for Transmitter
Signal Tracing and follow the steps shown there.
73,
Don W3FPR
On 6/26/2021 4:21 PM, VA1CQ wrote:
I am just completing the build of K2 Serial No. 6397. Everything was
going perfectly with all receiver tests and adjustments. Everything is
in spec.
Then I started the transmitter tests. I set the output power control
for 2.0 watts. Beginning on 40 metres, I am supposed to be able to
adjust L1 and L2 to measure 2 watts on the internal power meter. I
measure 0.1 to 0.2 watts. Nothing I adjust or do changes this. My
input voltage is 13.6V with 250 mA on receive and 600 mA on transmit.
I've taken a quick read through the Troubleshooting section, but I'm
wondering if I'm just doing something stupid and only think I have a
problem when I don't. Being new to the K2, perhaps I'm not setting
something correctly.
Any tips for what I should do next?
Murray VA1CQ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com