I have this behaviour on my Yaesu Ft-897. If I set the CW modulation to
700 kHz, then it will move to 1.700 MHz. I thought this was "normal"
behaviour, and I was afraid to ask about it (relatively new ham). I
haven't tried to do the same on my KX3, but I will get it out and try it.
I don't think this is due to dropping it - I think it is intentional to
give you the correct tone for CW.
Rgds.,
Paul
On 26/07/2021 19:05, Tom wrote:
Hi
I don't recall this happening before, but if I am tuned to a signal lets say
at 1.000 MHz in AM and then I switch to CW, the frequency display on the
radio changes to 1.600 MHz.
My K3 and KX2 do not do this. Is there a setting somewhere?
I did drop my KX3 at one point recently so I am wondering if a button or
worse was pressed.
Thanks, Tom
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
