The clicking relay turned out to be in an amplifier keying circuit a previous owner had installed.

Problem solved!

Dave K9SW


On 7/25/2021 5:51 PM, k...@comcast.net wrote:
Thanks, Don.  It’s a K2/10, so I’ll do the relay touch-test.

Dave   K9SW



On Jul 24, 2021, at 8:40 PM, Don Wilhelm <d...@w3fpr.com> wrote:

Dave,

I am at a loss to tell you what is going on.  The T/R switching in the K2 is 
all electronic, no relays involved.
If a K2/100, break it down to just the base K2 and see if it is in the base K2 
or in the KPA100.
If you have the K2/10, remove the top cover which contains the KAT2.

If it occurs in just the base K2, hold your finger on the relays one by one and 
see if you can detect which one is switching as you key the K2.

73,
Don W3FPR

On 7/24/2021 5:22 PM, K9SW wrote:
Recently bought a K2 and all was working well (silent QSK) until I moved from 
one spot on the bench to another.  It was powered up and one of the leads fell 
off the power supply connector, so this was a live power interruption.  After 
this, there are relay clicks when sending CW.  I did a reset, but this did not 
change the relay clicks.  Built the probe and did the CAL FIL routine and got 
it back on the air successfully.

S/N 100, with ATU and SSB board.

It would be nice to get back to silent QSK and preserve relay life.  Any 
suggestions appreciated!


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to k...@comcast.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com 

Reply via email to