To follow up on my question about the PLL range test, how critical is it to be at or below 15Khz? Currently I am at 15.40Khz after playing around with the winding spread. The errata sheet says to be between 9.98Khz and 15Khz difference in the high and low reading.
73 James, KJ4KEM > On 11/04/2021 7:57 PM Comcast <gun...@comcast.net> wrote: > > > Hello again, > Still building a K2. I got to the PLL reference oscillator range test and did > have to remove one turn from the toroid.My range at first was 20.6 Khz. > I got it down to 15.38Khz. I am worried if I remove another turn it will be > too low. I went ahead with the continued testing and all the numbers (test > results) are good. > I stopped for the night on the BFO alignment. > My questions is, is the 15.38Khz ok or do I need to remove another turn from > the toroid? > > 73 > > James, KJ4KEM > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to gun...@comcast.net ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
