Bob There has been a thread on the K4 groups.io on this subject. There is much more info concerning the K4 on there. While mine works correctly, some don’t. I think a pin needs cutting off, you might check with a breakout box.
73 Dave G4AON On Tue, 22 Feb 2022 at 14:53, Robert Sands <k7vora...@gmail.com> wrote: > My old cable, used with K3 and KPA500 works fine with K4 to KPA 1500 > except the K4 receive is shut down when 1500 in off, regardless of cable or > use of interruptor. Ideas? > > Happens Only on 40 and 75, not 20. No receive until 1500 is on. I also > tried the new cable. > Bob > K7VO > > On Tue, Feb 22, 2022, 5:27 AM Dave <dave.g4...@gmail.com> wrote: > >> No difference between using the K3 and K4. I use the same interconnection >> cable that I used for the K3. >> >> The K4 shows the power level against the power control knob as appropriate >> when you go from standby to operate. >> >> Power setting/control with the K4 and KPA500 is well controlled. >> >> 73 Dave >> K4D #286 >> KPA500 > > >> -- >> Sent from my iPhone SE >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:Elecraft@mailman.qth.net >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to k7vora...@gmail.com >> > -- Sent from my iPhone SE ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com